Lincoln Electric IM10136 VRTEX MOBILE - Manual (Page 36)

B-17 OPERATION (USER MODE) B-17
Theuserwillthenhavetochangeanysettingsthatare
incorrect.  If the settings are correct and the green
check settings icon is selected, the welder’s view
screenwillappearonthemonitorandinthehelmet’s
stereovisor.Theuserwillthenbeabletostartvirtual
welding.
MENU
Selecting Logout brings the user back to the login
screen,withtheuser’snameremoved.
BACk
SelectingBack goesbacktothepreviousscreen.
VIRTUAL WELDING OVERVIEW
While a user is welding, observers can see the
welder’s view, Live Action Student Evaluation Report
(LASER)screen,orinstructor’sviewdisplayedonthe
monitor.SeeFigureB.32.Thewelder’sviewshows
whattheuserwiththehelmetonisseeingthroughthe
FMD.  The Live Action Student Evaluation Report
(LASER)screendisplaysarealtimegraphoftheweld
beingmadeandgivesascorewhentheuserselects
“endpass”.Theinstructor’sviewallowsanotheruser
tozoomin/out,panandrotatethecoupontoviewthe
weldmentfromdifferentanglesinrealtime.
UPPER OVERLAYS
Theweldingtechniquesetinthetoleranceeditorand
otherprocessdetailsaredisplayedontheupperright
portionofthescreen.
MENU
Selecting Logout brings the user back to the login
screen,withtheuser’snameremoved.
ORANGE ACTION AND CUES ICON
The orange action menu icon has the following
options:
•Quench
•“Cheater”Lens–Off,1.25X,1.5X,1.75X,2X
•TravelSpeedVisualCue
•AIM
•Travel/WorkAnglesVisualCue
•CTWD(ContactToWorkDistance)VisualCue
•Trim
•Weave
•Whip(SMAWonly-Optional)
These options are only available when applicable to
theweldingprocess.
Trim cuts back the VR GMAW or VR FCAW wire.
Quench simulatesquicklycoolingthemetal.
VRTEX ® MOBILE
FIGURE B.30 – INCORRECT WELD
SETTINGS SCREEN
FIGURE B.31 – CORRECT WELD
SETTINGS SCREEN
FIGURE B.32 – USER SCREEN VIEW