Lincoln Electric IM10136 VRTEX MOBILE - Manual (Page 27)

B-8 OPERATION (INSTRUCTOR MODE) B-8
TOLERANCES: EQUIPMENT
SETTINGS SCREEN
OVERVIEW
Thisscreenallowsforthemodificationofthefollowing
weldingparameters(SeeFigureB.11):
•WireFeedSpeed
•Amperage
•Voltage
•Polarity
TOLERANCES: GAS SCREEN
OVERVIEW
Thisscreenallowsforthemodificationof(SeeFigure
B.12):
•GasMixtureSelected
•GasFlowRate
TOLERANCES: WELDING
TECHNIQUE PARAMETERS
SCREEN
OVERVIEW
This screen allows the modification of (See Figure
B.13):
•CTWD/ArcLength
•WorkAngle
•TravelAngle
NOTE: The travel angle for drag welding techniques
should always be less than 90 degrees.  The
travel angle for pushing technique should
alwaysbegreaterthan90degrees.
VRTEX ® MOBILE
FIGURE B.11 – EQUIPMENT
SETTINGS SCREEN
FIGURE B.12 – GAS SCREEN
FIGURE B.13 – WELDING
TECHNIQUE PARAMETERS