Melnor 3050 User Manual
Page 8
3) TO SET STOP TIME OF 1ST CYCLE
Press
ᮤ
or
ᮣ
to select Stop Time HOUR. Unit will beep one (1) time for each key press.
Holding down key will scroll numbers for faster selection.
Press ACCEPT ▼ when desired Stop Time HOUR flashes.
Unit will beep one (1) time and minutes will flash.
Press
ᮤ
or
ᮣ
to select Stop Time MINUTES. Unit will beep one (1) time for each key press.
Holding down key will scroll numbers for faster selection.
Press ACCEPT t desired Stop Time MINUTES flash.
Unit will beep one (1) time.
If in 12-hour mode, press ACCEPT t after selecting proper AM/PM setting using
ᮤ
or
ᮣ
. Unit will go directly to
Mist Cycle setting.
This AM/PM step is skipped for 24-hour mode and unit will go directly to Mist Cycle setting.
4) TO SET MIST CYCLE
Misting means that the timer will repeatedly open an close valve during the cycle for intermittent watering.
Press
ᮤ
or
ᮣ
to select one of the following:
No = no misting: the timer waters continuously throughout entire cycle.
2 min = the timer will repeatedly water for 2 minutes, stop for 10 minutes, then restart.
5 min = the timer will repeatedly water for 5 minutes, stop for 10 minutes, then restart.
10 min = the timer will repeatedly water for 10 minutes, stop for 10 minutes, then restart.
15 min = the timer will repeatedly water for 15 minutes, stop for 10 minutes, then restart.
Press ACCEPT ▼ to choose desired flashing Mist Cycle. Unit will beep and flash two (2) times and go to
Water Days setting.
Note: Repeat steps 2-4 above for each additional cycle desired.
ACCEPT
ACCEPT
ACCEPT