Ramsey Winch HDGY-350R W/4.5 CID MOTOR - Manual (Page 11)

9
13. Press bearing #16 onto worm and into
housing. NOTE: Be sure that thick
shoulder of bearings outer race (side with
manufacturer's name and part number) is
out, away from worm threads. Place
gasket #30 onto adapter #2. Attach
adapter to gear housing using four (4)
capscrews #23. TIGHTEN CAPSCREWS
TO 12 FT. LBS. (16.3 Nm.) EACH. Insert
keys #13 into keyways of worm shaft.
Slide tapered end of coupling #6 over end
of worm shaft. Be sure roll pin #39 is in
coupling.
Place motor shaft, with key in keyway, into
coupling. Secure motor to adapter, using
two (2) capscrews #24 and lockwashers
#28. TIGHTEN CAPSCREWS TO 75 FT.
LBS. (102 Nm.) EACH.
14. Place winch with gear housing cover down
on work bench. Drum shaft should be in
vertical position. Slide thrust washer #46
over drum shaft and slide downward until
washer rests on gear housing. Set springs
#44 into pockets of gear housing with
drag brakes #29 on top of springs. Slide
drum assembly #8 onto drum shaft with
drum jaws upward.