Ramsey Winch HDGY-350R W/4.5 CID MOTOR - Manual (Page 9)

7
5. Remove gear housing cover #7 from gear
housing #11 by unscrewing capscrews
#19. Thread two of the capscrews into
the two tapped holes of cover and tighten.
This will pull the cover loose from gear
housing.
Remove cover gasket #31 and pull shaft
#14, with gear attached, and thrust
washer #47 from gear housing.
6. Check for signs of wear on gear teeth. If
replacement of gear is necessary, replace
as follows:
a. Press gear #9 from shaft #14.
b. Examine shaft keys and keyways.
If distortion of keys and/or keyways
is evident, shaft and keys should be
replaced.
c. Use a soft hammer to gently tap keys
#33 into keyways. Press gear #9
over shaft and keys. Gear must be
centered over keys.
7. Remove seal #43 from back of #11 gear
housing. Press bushing #18 from gear
housing. Press new bushing and seal back
into place.
8. Check drum bushings #17 for signs of
wear. Replace if necessary by pressing
old bushings from drum. Press new ones
into place.