Ramsey Winch HDGY-350R W/4.5 CID MOTOR - Manual (Page 12)

10
39
10
35
37
38
15. Place thrust washer #47 over end of drum
shaft and slide downward until spacer rests
on drum. Press drum downward to
compress springs in gear housing.
Insert keys #32 into keyways with sharp
edge of keys pointing outward and notched
end of keys upward. A rubber or brass
mallet will be needed to gently tap keys into
position.
Apply grease to keys and end of shaft.
Place jaw clutch #5 over end of shaft and
slide jaw clutch over keys.
Set clutch housing #12 over end of drum
shaft. Pull jaw clutch #5 upward, toward
clutch housing, enough to allow yoke, in
clutch housing, to fit properly in groove
around jaw clutch.
16. Insert plug #38 into bottom of gear
housing. Permatex may be applied to
threads to help prevent leakage.
Attach handle #10 to clutch shaft using
pin #39.
Pour 1 pint of SAE 140 EP gear oil into
housing through hole in top of housing.
Insert relief fitting #35 into reducer #37.
Reducer should then be placed into hole on
top of gear housing. Tighten fitting and
reducer securely.