Ramsey Winch HDGY-350R W/4.5 CID MOTOR - Manual (Page 7)

5
39
10
35
37
38
TROUBLE SHOOTING GUIDE
CONDITION POSSIBLE CAUSE CORRECTION
Clutch inoperative or binds up. 1. Dry or rusted shaft.
2. Bent yoke or linkage.
3. Clutch jaws are in contact
1. Clean and lubricate.
2. Replace yoke or shaft
assembly.
3. See Techniques of Operation
Oil leaks from housing 1. Seal damaged or worn.
2. Too much oil.
3. Clutch jaws are in contact.
1. Replace seal.
2. Drain excess oil. Refer to
Techniques of Operation.
3. Replace gasket.
Winch runs too slow 1. Hydraulic motor worn out.
2. Low flow rate.
1. Replace motor.
2. Check flow rate. Refer to
Hydraulic Systems flow
chart, page 4.
Cable birdnests when clutch is
disengaged. 1. Drag brake disc worn. 1. Replace discs.
Hydraulic fluid leaks out hole in
motor adapter. 1. Hydraulic motor shaft seal
damaged.
1. Replace seal.
INSTRUCTIONS FOR OVERHAUL OF HDG-350
DIS-ASSEMBLY
1. Drain oil from gear housing by removing
plug #38 from bottom of gear housing.
Remove plugs #35 & #37 from top of
gear housing. Remove handle #10 by
driving pin #39 from shifter shaft of winch.