Ramsey Winch HDGY-350R W/4.5 CID MOTOR - Manual (Page 8)

6
2. Remove clutch housing #12 and clutch
#5 from winch assembly.
Remove two keys #32 from keyways. A
screwdriver can be used, at notch, to aid in
the removal of keys. Once keys have been
removed, drum #8 and thrust washer #47
can be removed from drum shaft.
3. Remove motor #36 and coupling #6 from
adapter #2 by unscrewing two capscrews
#24 with lockwasher #28.
Remove keys #13 from worm shaft.
Unscrew four capscrews #23 and remove
adapter #2 from gear housing. Replace
adapter seal #42 and gasket #30.
4. See page 12 for servicing the oil cooled
brake. Remove brake housing mounting
screws #22 and remove brake with
gasket. Replace gasket #30. Remove
worm #15 and bearings #16 from gear
housing. Use soft hammer to gently tap
input end of worm and drive worm and
bearing from gear housing. Once worm
has been removed from housing, bearing
can be pressed from end of worm.
Check for signs of wear or damage to
worm #15 and bearing #16. Replace if
necessary.