Rapid-Air MINI-SERVO FEED: MS2, MS4 & MS8. 115vac, 1ph, 60hz - Manual (Page 10)

0
NEVER.– Put screwdrivers or foreign materials in feed rolls
NEVER.– Hold onto material as it is being fed through the servo
NEVER.– Wear neckties around the servo feed rolls
NEVER.– Force the rolls open by prying on them
NEVER.– Modify the mechanical aspects of the servo feed
CAUTION.– Contact the factory before drilling any holes in the unit
CAUTION.– Wear proper eye protection when working around the servo
CAUTION.– Do not wear loose clothing around the servo feed rolls
PreCAUTions & sAfeTy
Precautions.&.safety