Rapid-Air SERVO FEED GAG FEED: 950 SERIES - Manual (Page 2)

1
Gag Feed Program
The standard “GAG” feed program is a multiple feed length program within a specified
job number. The different programmed feed lengths will be referrred to as sequences.
Each sequence can be repeated many times with a choice of using any combination of
8 outputs per sequence . Although this is the standard program, Rapid-Air can
program other configurations in any combination to meet the customer’s requirements.
The standard “GAG” feed program has 10 jobs with 10 programmable sequences per
job. Each sequence can be a different feed length which can be repeated up to 99
times. The following chart depicts the previous write-up.
GAG FEED
TOTAL JOBS 10
TOTAL SEQUENCES 10
TOTAL REPEATS 99
TOTAL OUTPUTS 08
The job, sequence, repeats and outputs are software programmable. The output will
activate when the sequence is activated and remain activated until the next sequence.