Rapid-Air SERVO FEED GAG FEED: 950 SERIES - Manual (Page 29)

28
TROUBLESHOOTING CHART (cont.)
PROBLEM CAUSE REMEDY
Material feeds off Edge guides not set Set edge guides
center properly
Material not centered Center material
in feed
No automatic cycle No press signal Check limit switch
input to servo control
Controller fault Check lights on P.C.
Servo fault Check lights on drive
Program error Check parameters
Servo squeals while Servo velocity gain Consult factory
in position too high
Fault signal on Pac-Sci Servo fault Check fault chart
is displayed Material jam Check die
Power surge/failure Check/recycle power
Cannot program unit Program fault Check Pac-Sci &
Call factory.
Mechanical pilot release Too much overtravel Restrict travel of
sticks down mechanical actuating
arm
Broken spring Remove plate and check
springs
Needs lube Remove plate and
lubricate release bar