Progressive International Electronics C2000 - Manual (Page 30)

C2000 Program & Report
‚ 24
Mode 7 — Print Header (Manager only)
In this mode, the print header for the printer receipt is created
and edited. (Note that this mode is accessible only if the printer
has been enabled in Mode 6.) To enter this mode, enter <7> on
the keypad and press <ENTER>.
The display shows the beginning information for the printer
header. If your header has not been programmed or has been
cleared, the curser will prompt you for your first character
entry. (Refer to Table 6, Print Header Character Codes, for a
numeric code which represents the characters available for your
use on the printer header.) Determine the character you wish to
place in the first position of the header and look up the numeric
code. Enter this numeric code on the keypad and press
<ENTER>. The character will appear on the display, and has
been saved in memory. For each subsequent character, follow
the sequence described above.
There are two special numeric codes for the header: <10>
indicates a new line in the header; <01> is the code for end of
header. Enter the new line code at the point where the printer
should cease printing on the current line and go to the
beginning of the next line. The end of header code is entered
after the entire header is entered and will tell the C2000 that no
more characters are needed in the header.