Progressive International Electronics C2000 - Manual (Page 32)

C2000 Program & Report
‚ 26
Special editing features are available for use in this mode:
<ENTER> without entering a numeric code — The display
curser will increment to the next character in the header.
<SELECT> without entering a numeric code — The display
curser will go back one character in the header.
<CHANGE> without entering a numeric code — The entire
printer header will be cleared.
<PRINT> without entering a numeric code — The printer will
print the header that is programmed.
<MANAGER> — Exit Mode 7.
Mode 10 — Read Reports (Manager/Operator)
In Mode 10, totals reports may be generated and displayed. To
enter this mode, enter <10> on the keypad and press
<ENTER>.
The display will show an R:0, prompting you to enter a report
type code. Use the table below to select which type of report
you would like displayed.
1 Resettable Totals
2 Non-Resettable Totals
3 Shift 0 Totals (current shift)
4 Shift 1 Totals
5 Shift 2 Totals
6 Shift 3 Totals
7 Polled Pump Totals