AMX Wireless Touch Panels (Wave Server) - Manual (Page 40)

30 Designing Touch Panel Pages ViewPoint Wireless Touch Panels
b. For 2-way ViewPoints, AMX IR is not supported (38 KHz and 455 KHz) but
other manufacturer’s IR codes are supported by assigning ViewPoint device
numbers 2, 3, and 4 for IR codes.
3. Press ENTER to store the device number into memory, close the keypad, and
return to the Button Properties page.
4. Press CHAN to open a keypad and enter a channel value of 1 through 255 in the
keypad. The AXCESS software program uses the channel code number to
identify the button and its’ programmed operations.
5. Enter 1 through 255 in the keypad. The AXCESS software program uses the
channel code number to identify the button and its operations.
6. Press ENTER to store the channel number in memory, close the keypad, and
return to the Button Properties page.
Setting the variable text code
The variable text buttons that set the device and button channel codes for the touch
panels are shown in Figure 37.
1. Press DEV to open a keypad and set the device number.
2. Enter 1, 2, 3, or 4 in the keypad. The AXCESS software program uses device
codes 1 through 4 to identify the touch panel. Refer to the Touch Panel Program
Reference section in this manual for detailed information.
3. Press ENTER to store the device number in memory, close the keypad, and
return to the Button Properties page.
4. Press CHAN to open a keypad and set the channel number.
5. Enter a channel value of 1 through 255 in the keypad. The AXCESS software
program uses the channel code number to identify the button and its operations.
6. Press ENTER to store the channel number into memory, close the keypad, and
return to the Button Properties page.
Note
If DEVICE USED is set to 4
and Base Device Number is
128, the Central Controller
recognizes bus devices 128,
129, 130, and 131.
Note
The channel code for non-
active buttons is 0 and for
active buttons is 1 through
255.
Note
One-way ViewPoint touch
panels do not support variable
text.
Figure 37
VAR TEXT code button
Note
The panel will not allow you to
enter a device number greater
than the DEVICE USED
without first displaying a
decision box. This box asks
you to decide whether you
accept the new selection or
default to the previous value.
Note
The channel codes for non-
active buttons is 0, and active
buttons is 1 through 255.