AMX Wireless Touch Panels (Wave Server) - Manual (Page 56)

46 Designing Touch Panel Pages ViewPoint Wireless Touch Panels
Setting the channel code
The channel buttons that set the device and button channel codes for the touch panels
are shown in Figure 58.
1. Press DEV to open a keypad and set the joystick’s device number.
2. Enter 1, 2, 3, or 4 in the keypad. The device number specifies the device number
that the selected channel’s feedback displays.
3. Press ENTER to store the device number into memory, close the keypad, and
return to the Button Properties page.
4. Press CHAN to open the keypad and enter a channel value of 1 through 255 in
the keypad. The AXCESS software program uses the channel code number to
identify the button and its’ programmed operations.
5. Press ENTER to store the channel number in memory, close the keypad, and
return to the Button Properties page.
Figure 57
Button Properties page for
Joysticks
Note
If you followed the instructions
for Adding a joystick to a page
subsection, this button's
Properties page appears.
Note
If DEVICE USED is set to 4
and Base Device Number is
128, the Central Controller
recognizes bus devices 128,
129, 130, and 131.
Figure 58
CHANNEL code buttons
Note
The panel will not allow you to
enter a device number greater
than the DEVICE USED
without first displaying a
decision box. This box asks
you to decide whether you
accept the new selection or
default to the previous value.
Note
The channel code for non-
active buttons is 0 and for
active buttons is 1 through
255.