Alliance Laundry Systems UF18PNV - Manual (Page 27)

Programming
26 F232072
Cycle Programming (Continued)
Agitation Speed
If “AgSn” is selected, the machine uses the normal
wash speed for the duration of the cycle. If “AgSL”
is selected, the machine uses the gentle wash speed.
Gentle wash speed is approximately half the speed
of the normal wash speed.
Recirculation Pump
This cycle option setting is intended to be used with
a possible future recirculation application. Selecting
either “nPMP” or “PUMP” will have no bearing on
the wash cycle. However, the “nPMP” setting is
recommended to prevent the corresponding output
on the output board from energizing.
Press the Start key after selecting this last cycle
option setting to begin editing the cycle segments.
Segment Programming
All cycle programs (“CY1”–“CY30”) can be
customized within a preset program structure. Each
cycle program consists of eleven program segments.
See the following table.
.
When modifying a cycle, a time must be entered for
each segment. To skip a segment or spin, set the
time to “00” and press the Start key. The following
table gives the time parameters for each segment
and spin, as well as the allowable temperature
range.
Note: Spin times in cycle segments 1–10 are
entered in seconds (30 to 240), and time for final
spin in segment 11 is entered in minutes (1 to 10).
Cycle Program Segments
Segment Display Segment Display
Prewash PrE Fill 5 FIL5
Wash UASH Fill 6 FIL6
Fill 1 FIL1 Fill 7 FIL7
Fill 2 FIL2 Fill 8 FIL8
Fill 3 FIL3 Fill 9 FIL9
Fill 4 FIL4
Time and Temperature Parameters
Function Minimum Maximum
Prewash 2 minutes 30 minutes
Wash 2 minutes 20 minutes
Fill 1 2 minutes 15 minutes
Fill 2 2 minutes 15 minutes
Fill 3 2 minutes 15 minutes
Fill 4 2 minutes 15 minutes
Fill 5 2 minutes 15 minutes
Fill 6 2 minutes 15 minutes
Fill 7 2 minutes 15 minutes
Fill 8 2 minutes 15 minutes
Fill 9 2 minutes 15 minutes
Intermediate 30 seconds 240 seconds
Final Spin 1 minute 10 minutes
Temperature 75°F / 25°C 200°F / 93°C