Alliance Laundry Systems UF18PNV - Manual (Page 35)

Programming
34 F232072
Segments 3 – 10 (Fills 1 – 8)
Display
Instructions
Use Up or Down key to change. Press Start key to enter or advance.
FIL1, FIL2, FIL3, FIL4, FIL5, FIL6, FIL7, or FIL8
00 or 02 to 15 Select segment time: 02 to 15 minutes (00 to skip segment).
tFIL Indicates temperature fill is enabled.*
HFIL, CFIL, bFIL,
or AFIL Select “HFIL” (hot fill), “CFIL” (cold fill), “bFIL” (warm fill), or “AFIL”
(auxiliary fill).**
LO, Med, or HI Select fill level: “LO” (low), “Med” (medium), or “HI” (high) water level.
SUP0–SUP7 Select supply 0 – 7 (0 for no supply).***
00°F, 75°F–200°F
00°C, 25°C–93°C
Select temperature: 75 to 200° F or 25 to 93° C (00 for no heat).†
drAI or nodr Select drain option: “drAI” (drain), “nodr” (no drain)‡
SPIn (flashed for one second)
tIME (flashed for one second)
00 or 30 to 240 Select time for spin: 30 to 240 seconds (00 for no spin)
* This is displayed only if temperature-controlled fills are enabled in the SETUP options and if the heat
temperature is set to a value other than “00.”
** “AFIL” can be selected only if the “SUP5”/“AFIL” SETUP option is set to “AFIL.”
*** “SUP5” and “SUP6” can be selected only if the “SUP5”/“AFIL” SETUP option is set to “SUP5.”
† This value is not available when temperature-controlled fill and auxiliary heat SETUP options are
disabled.
‡ If “nodr” is selected, the computer skips the spin step and goes on to the next segment.