Atlantis A02-PL303-WN - Manual (Page 24)

24
 Enable: Select to activate the device’s UPnP
function.
 Disable: Select to inactivate the device’s UPnP
function.
DHCP SERVER
DHCP allows networked devices to obtain information on the parameters of IP,
Netmask, and so forth through the Ethernet Address of the device.
To configure the device’s DHCP Server, select Server from the DHCP Type dropdown
menu and you can then configure parameters of the DHCP Server.
DESCRIPTION MEANING
DHCP Start IP /
End IP Enter the starting and ending IP address of the range of IP
addresses that you want the DHCP server to assign to DHCP
clients. The default DHCP IP range is
192.168.1.10 to 192.168.1.50.
DHCP Subnet Mask Enter the subnet mask for the network address that you
specified. The default is 255.255.255.0.
DHCP Lease Time Enter the time value (in seconds) that you want the assigned
IP address to be valid for. The DHCP client must obtain a new
IP address from the DHCP server when this value expires.
Statically IP
Assigned (1-3) You can map the MAC address for stations that you want to
always be assigned the same IP address. Mapped IP addresses
must be outside the DHCP start/end IP range. You can
configure up to 3 sets of MAC and IP addresses in this table.