Atlantis A02-PL303-WN - Manual (Page 26)

26
Network Name
(SSID1)
(SSID2)
(SSID3)
(SSID4)
The SSID is the unique name of a wireless access point (AP)
used to distinguish one from another. For security purpose,
you should change the default SSID to a unique ID name that
is difficult to guess. Make sure your wireless clients have
exactly the SSID as the device in order to connect to your
network.
It is case sensitive and can be up to 32 characters.
Multiple SSID
Service
We can set Multiple SSID service as below picture. We can set
4 SSID Maximum.
Each SSID can set different Security setting.We can choose the
SSID which we want to configure in SSID choice option.
Multiple SSID
Isolation
The “Multiple SSID Isolation” function will isolate the data
forwarding between different SSID.
Client Isolation The “Client Isolation” function will isolate the data forwarding
in same SSID.
Broadcast Network
Name (SSID)
It is used to broadcast its SSID on the network so that when a
wireless client searches for a network, the device can be
discovered and recognized. Default setting is Disable.
 Enable: When enabled, the SSID is broadcast for
wireless users to use.
 Disable: When disabled, prevents the SSID
broadcast from being seen by wireless users.
Country Region Please select the region where NetPower 303 WN is used.
Frequency
(Channel)
Select the wireless connection ID channel that you would like
to use.
Wireless performance may degrade if the selected ID channel
is already being occupied by other AP(s).
Channel Bandwidth Select either 20 MHz or 20/40 MHz for the channel bandwidth.
The higher the bandwidth the better the performance will be.
BSSID Displays the MAC address of the device.
WDS Available when 11b/g mixed mode, 11b only and 11g are
selected in Network Mode. Select the data transmission rate
from the drop-down menu. Default is Auto.