Yokogawa BT200 - Manual (Page 41)

<Toc> <Ind> <5. USING THE BT200 FUNCTIONS >
5-11
IM 01C00A11-01E
(3) LCD CONTRAST CONTROL
The BT200 features software capability to control
the LCD contrast. There are two ways to control the
LCD contrast.
a) CONTROLLING THE LCD ON THE
STARTUP PANEL
While the startup panel is on display, press [<] or
[>] to call the LCD contrast panel directly.
F0513.EPS
Lighter.
Darker.
Set. LCD
LCD contrast adjust
Low High
push [<][>] key
ESC
[F4] ESC ➝ Return to the utility
panel.
--WELCOME--
BRAIN TERMINAL
ID:BT200
check connection
push ENTER key
UTIL FEED
or
b) CONTROLLING THE LCD ON THE UTILITY
PANEL
Select ‘4. LCD CONTRAST’ from the utility
panel and press [ENT] to select the LCD contrast
control panel. Use [<] or [>] to control the LCD
contrast. When finished, press [ENT] to set the
BT200 to the specified LCD contrast level.
(4) PRINT DENSITY CONTROL
You can control the print density while printing test
copies.
F0514.EPS
PRINTER
printer adjust
Low High
push [<][>] key
F2:print test data
FEED GO ESC
[F1] FEED
[F2] GO
[F4] ESC ➝ Paper feed
➝ Start test printing
➝ Return to the utility
panel.
1. Select ‘6. PRINT DENSITY
CONTROL’ from the utility
panel.
2. Press [F2] GO on panel 1 to
start test printing.
(Press [F4] STOP to cancel
printing.)
3. Verify that test printout and
use [<] or [>] to control the
print density.
1
᭺
!”#$%&’()*+,-./
0123456789:;<=>?
@ABCDEFGHIJKLMNO
PQRSTUVWXYZ[\]^_
Ժ abcdefghijklmno
p q r s t u v w x y z { } ˜
Repeat Steps 2 and 3 to finally
control the print density.
Test printout