Yokogawa BT200 - Manual (Page 48)

<Toc> <Ind> <APPENDIX>
A-1
IM 01C00A11-01E
APPENDIX A
1. Setting and Changing SECURITY CODE
The BT200 is shipped without a security code set. You
can alter setup data without having to register a
security code. If you set a security code, you need to
type it only once during the first setup change proce-
dure after the BT200 is switched on. The security code
is a series of four digits (0 through 9).
A) SETTING A SECURITY CODE
To register a security code in the BT200 as shipped,
follow these steps.
SECURITY
new SECURITY CODE
:_
CODE clear mode
CLR ESC
F0A01.EPS
SECURITY
new SECURITY CODE
:****
re-enter new CODE
:_
CLR ESC
UTILITY
1.ID
2.SECURITY CODE
3.LANGUAGE SELECT
4.LCD CONTRAST
5.PRINTER ADJUST
CLR ESC
1. Select ‘2. SECURITY CODE’
from the utility panel and
press [ENT] to select the
security panel .
2. Type a string of four digits (0
through 9) and press [ENT].
Note: The security code must
be numeric and four
digits long.
3. Type the security code again
and press [ENT] to complete
the procedure.
1
᭺
2
᭺
3
᭺
1
᭺