Yokogawa Standalone MW100 - Manual (Page 20)

DX Advanced / MW100 Data Type Usage Explanation
In the tables above, INT, INT32, and Float addresses are shown for the same Measurement Channel. Any of the data
type may be used dependant on the application. For example, with an SLC 5/05, if the data from the DX Advanced or
MW100 Measurement Channel #1 was required to be in a Float (Real) format when received by the PLC, address F10:0
would be used. If needed in an INT format, N10:0 would be used.
*2
A FLOAT value with the same number of decimal places as the one specified for
the channel is converted to INT16. Other numbers are ignored. Example: If the
number of decimal places of channel 201 is "2" (For example, the range can be
set is from -200.00 to 200.00).
A FLOAT value up to two decimal places is rounded to an integer. See the
example in the following table.
Values are written as follows:
17