Nexo GEO T - Manual (Page 30)

Page 30/67 GEO T RIGGING PROCEDURE
15˚ 12.5˚
10˚
8˚
6.3˚
Se tti ng Po sit ion s
Co m p res sio n
IMPORTANT
DO NOT attempt to make any changes to the linking bars whilst the system is landed or
being lifted or lowered.
•
4.4.4 Subsequent GEO T4805’s
• Repeat the above section steps, until six GEO T4805 are in place. As the assembly is lifted,
angles between GEO T4805 cabinets will remain at 0° whatever the linking bar positions.
• NB : In “Compression Mode”, the linking bars are free to be adjusted while the system is clear of
the ground, provided that rear pull-up force is not applied.
• Once the GEO T4805 assembly is completed, connect the bottom bumper to the last GEO T
4805 with the 12mm x 30mm push-pins inserted in the position marked “Safety Pin Must Be
Inserted” (see drawings below).
• Check the array according to the Checklist procedure described later in this manual.
4.4.5 Last GEO T4805 to first GEO T2815
IMPORTANT
Unlike GEO T 4805, GEO T2815 does not have the 0° safety
position.
“Compression Mode” only applies to GEO T4805. GEO T2815’s must
always be installed in “Tension Mode”.
• Follow the instructions given in section 3.3.4 for fitting GEO
T2815 cabinets in tension mode.
• Check that all push-pins are locked and that angle settings are
identical on each side.
4.4.6 First to second GEO T2815
In “tension mode” position, the upper oblong hole and the upper hole
series is used for 6.3°, 8.00°, 10.0°, 12.5° and 15° angle settings.
• Repeat the above section steps, until you have positioned the
required number of GEO T2815 cabinets.
• Connect the speaker links.
• Check the array according to the Checklist procedure.