3 architects’ & engineers’ specifications – Nexo GEO T User Manual

Page 53

Advertising
background image

T

ECHNICAL

S

PECIFICATIONS

Page

53/67

537 mm

537 mm

[21.14"]

[21.14"]

750 mm

750 mm

[29.53"]

[29.53"]

903 mm

903 mm

[35.55"]

[35.55"]

213 mm

213 mm

[8.39"]

[8.39"]

249 mm

249 mm

[9.80"]

[9.80"]

7.2.2 GEO T2815 Dimensions

7.2.3 Architects’ & Engineers’ Specifications

The 2-way full range tangent array module shall have two 8 inch 16 Ohm long excursion neodymium hi-
flux cone transducers in series, two rear passive acoustic resistors and a 1.4 inch exit 16 Ohm
neodymium compression driver on a hyperboloid reflective wavesource. Coverage shall be
configuration-dependent in the vertical plane and 120° in the horizontal plane. The system shall have a
nominal sensitivity of 107dB (105dB wideband). When driven by a NEXO NX242 Digital TDcontroller
properly connected to amplification capable of delivering 5200 Watts into a 5 Ohm load (6 cabinets per
channel in parallel), the system shall produce 135dB peak SPL (for a single enclosure: configuration-
dependent when arrayed) with a frequency response of 85 Hz to 19 kHz ±3 dB (77 Hz to 20 kHz ±6 dB).
The system shall have an active crossover with DSP algorithms and a crossover point of 1.3 kHz.
Electrical connections shall be made via one 6 pole AMPHENOL EP6 socket and one 6 pole
AMPHENOL EP6 plug. The system shall have a 15° trapezoidal enclosure constructed of 18 ply Baltic
birch (midsection) and aluminium, finished in structured black coating and having exterior dimensions
no greater than 249mm H x 903mm W x 537mm D (9 13/16 in H x 35 1/2 in W x 21 1/8 in D): the
system shall weigh 29kg (63.9 lbs). Exterior hardware shall include an integral array assembly system
with logarithmic steps and 0.01° precision: interior components shall be protected by an injection-
molded polyurethane Configurable Directivity Device flange. The full range system shall be the NEXO
GEO T2815 with a NEXO NX242 Digital TDcontroller. Other integrated loudspeaker/controller systems
shall be acceptable, provided submitted results of testing by an independent laboratory verify that the
above specifications are equalled or exceeded.

Advertising
This manual is related to the following products: