Nexo GEO T - Manual (Page 35)

GEO T RIGGING PROCEDURE Page 35/67
ATTACHING THE LEVA1500 CHAIN TO THE KELPING BEAM
4.5.2 Bumper to fist GEO T4805 assembly
4 push-pins (BLGEOT12-35, 12mm diameter x 35 mm length) connect the top GEO T4805 to the
bumper.
IMPORTANT
These 4 push-pins are slightly longer than the ones used to connect GEO T’s (35mm
length instead of 30mm).
Never use the GEO T 12mm x 30mm push-pins to connect the top GEO T4805 to the
bumper.
FIRST GEO T4805 TO BUMPER ASSEMBLY
• Position the bumper on the first GEO T4805 so that the bumper side slot (A) is at the rear.
• Link the GEO T4805 to the bumper using the four 12mm x 35mm push-pins provided with the
bumper; depress the button at the rear of the pin to release the locking mechanism, insert the pin
fully, and release the button.
• Link the GEO T4805 to the bumper using the four 12mm x 35mm push-pins provided with the
bumper; check that all push-pins are in their locked position.
• Ensure that no objects have been placed accidentally on the top of the bumper as they may fall
when the system is lifted.
A