STI 07530WR - Manual

Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Toll Free: 800-888-4784 • E-mail: [email protected]
Web: www.sti-usa.com
Safety Technology International (Europe) Ltd.
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999
Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)
E-mail: [email protected] • Web: www.sti-europe.com
backbox mounting tab slot
mall
in closed position, against the wa
drill (4) 1/4 in. diamet
19033 anchors.
3
install shelf. Nex
through the acc
view A. Close and lock cabinet
wire
Drive in the (4) scre
of cabinet
optional mounting holes
diamet
mounting plat
drive the (2) alarm mounting scre
pre
the terminal switch diagram shown in view B.
4
scre
19033 ANCHOR
(4) PROVIDED
04875 MOUNTING PLATE
PROVIDED
19002 SCREW
#8-32 x 3/8 in.
(4) PROVIDED
OPTIONAL SHELF
MOUNTING POSITION
07530WR
ADJUSTABLE SHELF
INCLUDED WITH
STI-7531AED ONLY
07530 CABINET
ASSEMBLY
6297530
GASKET PROVIDED
06298
MOUNTING TABS
(4) PROVIDED
19013 SCREW
#10 x 1 1/2 in.
(4) PROVIDED
MOUNTING
TAB SLOTS
M
STI-7530 KEYLOCK
STI-7531 AND
STI-7531AED THUMBLOCK
INSTALLATION OF STI-7530, STI-7531 and STI-7531AED PROTECTIVE CABINET
All specifications and information shown were current as of publication, and are subject to change without notice.
7530IS NOV2010
INSTALLATION OF CABINET
1. Insert the (4) 06298 mounting tabs fully into back box
mounting tab slots. Use rubber mallet if necessary.
2. After selecting a suitable location, place cabinet in
closed position, against the wall. Mark and drill (4) 1/4
in. diameter holes. Insert the (4) 19033 anchors. Mount
cabinet by driving in the four #10 x 1 1/2 in. screws.
3. For STI-7531AED select one of the two shelf mounting
locations, install shelf. Close and lock cabinet.
CLEANING INSTRUCTIONS
1. Rinse cover with water to remove abrasive dust and dirt.
2. Wash with soap or mild detergent using a soft cloth. (DO
NOT SCRUB.)
3. Rinse once more, then dry with a soft cloth or chamois.
4. To remove grease or wet paint, rub gently with a cloth
wetted thoroughly with naphtha, then wash and rinse.
(DO NOT USE RAZOR BLADES
.)
Electronic warranty form at www.sti-usa.com/wc14
14.2 in.
(361mm)
12.2 in.
(310mm)
6.44 in.
(164mm)
TOP VIEW
FRONT VIEW
1/4” DIA.