Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 27)

To remove the wrsbc alias from the configuration, enter one of the following commands.
device(config)#no alias wrsbc
or
device(config)#unalias wrsbc
Syntax: unalias alias-name
The specified alias-name must be the name of an alias already configured on the Brocade device.
To display the aliases currently configured on the Brocade device, enter the following command at
either the Privileged EXEC or CONFIG levels of the CLI.
device#alias
wrsbc copy running-config tftp 10.10.10.10 test.cfg
shoro show ip route
Syntax: alias
Configuration notes for creating a command alias
The following configuration notes apply to this feature:
• You cannot include additional parameters with the alias at the command prompt. For example, after
you create the shoro alias, shoro bgp would not be a valid command.
• If configured on the Brocade device, authentication, authorization, and accounting is performed on
the actual command, not on the alias for the command.
• To save an alias definition to the startup-config file, use the write memory command.
Configuration notes for creating a command alias
FastIron Ethernet Switch Administration Guide 27
53-1003075-02