Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 308)

sysmon xbar error-count
Configures system monitoring for cross bar errors. The no form of this command resets the
parameters to default values.
Syntax sysmon xbar error-count { threshold events polling-interval | log-backoff value | action { none |
syslog } }
no sysmon xbar error-count
Parameters threshold
Defines the failure threshold for the cross bar error-count event. The threshold is defined as
N/W, where N is the number of events, and W is the number of consecutive polling periods.
When the threshold is reached, actions configured for this event type will take place. Note
that a threshold of 1/W implies that there is no threshold, and no event will be triggered.
events
Specifies the threshold in terms of the number of events. Valid values are 1 through
10.
polling-interval
Specifies the number of polling windows. The device polls the internal registers at the
interval specified by the sysmon timer value. Valid values 1-32. However, the polling
window number must be equal or greater than the number of events.
log-backoff
If an error condition persists, it will be continuously logged (internally and/or externally). The
log back-off count skips configured number of logs before logging again. This avoids
overflow of the internal log or of the syslog.
action
Specifies the action to take when the error count exceeds the specified threshold and log
back-off values.
none
No action is taken.
syslog
The error is logged to syslog.
Modes Global configuration mode.
Usage Guidelines This command is supported only on FSX devices.
Examples The following example configures system monitoring for cross bar errors.
Brocade(config)# sysmon xbar error-count threshold 3 7
Brocade(config)# sysmon xbar error-count action syslog
Brocade(config)# sysmon xbar error-count log-backoff 15
sysmon xbar error-count
308 FastIron Ethernet Switch Administration Guide
53-1003075-02