Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 283)

• Total PD power available to PSE
• Total PD power switched to PSE
In the absence of valid PSU power, the total PD power switched is equal to that available to PSE, as
shown in this example:
device#show inline power pd
Number of PD Ports: 2
Total PD Power Available to PSE: 22400
Total PD Power Switched to PSE: 22400
Port Oper Oper Fault/
State Mode Error
--------------------------------
1/2/1 On 802.3at n/a
1/2/2 On 802.3at n/a
The following shows an example of the show inline power pd display output on a PoE device with the
internal PSU up and no PD ports on:
device#show inline power pd
Number of PD Ports: 2
Total PD Power Available to PSE: 0
Total PD Power Switched to PSE: 0
Port Oper Oper Fault/
State Mode Error
--------------------------------
1/2/1 Off n/a n/a
1/2/2 Off n/a n/a
The following shows an example of the show inline power pd display output on a PoE device with the
internal PSU up and one PD port on in the AT mode:
device#show inline power pd
Number of PD Ports: 2
Total PD Power Available to PSE: 0
Total PD Power Switched to PSE: 0
Port Oper Oper Fault/
State Mode Error
--------------------------------
1/2/1 On 802.3at n/a
1/2/2 Off n/a n/a
The following shows an example of the show inline power pd display output on a PoE device with the
internal PSU down and two PD ports on in the AT mode:
device#show inline power pd
Number of PD Ports: 2
Total PD Power Available to PSE: 22400
Total PD Power Switched to PSE: 22400
Port Oper Oper Fault/
State Mode Error
--------------------------------
1/2/1 On 802.3at n/a
1/2/2 On 802.3at n/a
Syntax: show inline power pd
Field definitions for the show inline power pd command TABLE 41
Column Definition
Number of PD Ports The number of PD ports in the system.
Total PD Power
Available to PSE
Total PD power available to PSE.
Power over Ethernet
FastIron Ethernet Switch Administration Guide 283
53-1003075-02