Brocade FastIron Ethernet Switch Administration Guide - Manual (Page 343)

Explanation The port does not have a large enough CAM partition for the ACLs
Message Level Notification
Message ACL insufficient L4 session resource, using flow
based ACL instead
Explanation The device does not have enough Layer 4 session entries.
To correct this condition, allocate more memory for sessions. To allocate
more memory, enter the following command at the global CONFIG level of
the CLI interface:
system-max session-limit num
Message Level Notification
Message ACL port fragment packet inspect rate rate
exceeded on port portnum
Explanation The fragment rate allowed on an individual interface has been exceeded.
The rate indicates the maximum rate allowed.
The portnum indicates the port.
This message can occur if fragment thottling is enabled.
Message Level Notification
Message ACL system fragment packet inspect rate rate
exceeded
Explanation The fragment rate allowed on the device has been exceeded.
The rate indicates the maximum rate allowed.
This message can occur if fragment thottling is enabled.
Message Level Notification
Message Authentication Disabled on portnum
Explanation The multi-device port authentication feature was disabled on the on the
specified portnum .
Message Level Notification
Message Authentication Enabled on portnum
Syslog messages
FastIron Ethernet Switch Administration Guide 343
53-1003075-02