Brocade Multi-Service IronWare YANG Configuration Guide (Supporting R05.6.00) - Manual (Page 101)

Multi-Service IronWare YANG Configuration Guide 93
53-1003038-02
VLAN configuration elements
5
Uplink ports
This data element indicates which ports in the VLAN are connected to outside resources.
Router interface
This data element is the name of the router interface.
Loop detection
This data element indicates whether or not loop detection is enabled.
VLAN accounting
This data element indicates whether or not VLAN accounting is enabled.
NOTE
This data element is supported only on Brocade MLX series and Brocade NetIron XMR devices.
TABLE 24 Uplink ports
YANG model XML CLI
leaf-list uplink-switch
{
type ethernet-pos-intf-multiple;
description "List of Uplink ports to
enable "+
"uplink switching on this VLAN.";
} <brcd:uplink-switch>ethernet
1/4</brcd:uplink-switch> [no] uplink-switch ethernet <port-number>
[to <port-number> | ethernet
<port-number>]
TABLE 25 Router interface
YANG model XML CLI
leaf router-interface
{
type ve-intf-single;
description "router VE interface";
} <brcd:router-interface>ve 2</brcd:router-interface> router-interface ve <ve-number>
TABLE 26 Loop detection
YANG model XML CLI
leaf loop-detection
{
type empty;
description "Enable loop detection
on the VLAN";
} <brcd:loop-detection></brcd:loop-detection> [no] loop-detection