Brocade Multi-Service IronWare YANG Configuration Guide (Supporting R05.6.00) - Manual (Page 89)

Multi-Service IronWare YANG Configuration Guide 81
53-1003038-02
Full examples
4
<brcd:from>5.5.5.5</brcd:from>
<brcd:to>6.6.6.6</brcd:to>
<brcd:primary-path>example</brcd:primary-path>
<brcd:hop-limit>20</brcd:hop-limit>
<brcd:ipmtu>1526</brcd:ipmtu>
<brcd:ldp-tunneling></brcd:ldp-tunneling>
<brcd:metric>600</brcd:metric>
<brcd:record></brcd:record>
<brcd:reoptimize-timer>3600</brcd:reoptimize-timer>
<brcd:revert-timer>2999</brcd:revert-timer>
<brcd:secondary-path>
<brcd:name>example2</brcd:name>
</brcd:secondary-path>
<brcd:mpls-priority>
<brcd:hold-priority>6</brcd:hold-priority>
<brcd:setup-priority>6</brcd:setup-priority>
</brcd:mpls-priority>
<brcd:mpls-traffic-eng>
<brcd:max-burst>214748364</brcd:max-burst>
<brcd:max-rate>214748364</brcd:max-rate>
<brcd:mean-rate>4500</brcd:mean-rate>
</brcd:mpls-traffic-eng>
<brcd:enable></brcd:enable>
</brcd:lsp>
<brcd:rsvp>
<brcd:refresh-interval>360</brcd:refresh-interval>
<brcd:refresh-multiple>255</brcd:refresh-multiple>
</brcd:rsvp>
</brcd:mpls-config>
</brcd:netiron-config>
</nc:config>
</nc:edit-config>
</nc:rpc>
]]>]]>
The following example shows the complete CLI for an MLPS configuration.
Brocade# show run
Current configuration:
!
ver V5.2.0T183
!
!
no spanning-tree
!
!
vlan 1 name DEFAULT-VLAN
!
vlan 4089
untagged ethe 2/1 to 2/2
!
!
system-max vlan 4095
system-max virtual-interface 4095
!
aaa authentication enable default radius tacacs+ local
aaa authentication login default local radius tacacs+
aaa authentication login privilege-mode