Brocade ICX 6450-C Compact Switch Hardware Installation Guide User Manual
Page 26
CAUTION
Ensure that a minimum of 7.62 cm (3 in.) of space above the device and between the front and
the back of the device and walls or other obstructions for proper airflow.
NOTE
You need a #2 Phillips screwdriver for rack mount installation.
Complete the following steps to mount devices in rack.
1.
Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
brackets and six sink-head screws.
2.
Using a Phillips screwdriver, attach the mounting brackets to the sides of the device using six
sink-head screws, as illustrated in the figure below.
FIGURE 9 Attaching the mounting brackets for an ICX 6450-C device
3.
Remove the two-post rack kit from the shipping carton. The kit contains four rack-mounting
screws and four cage nuts.
4.
Insert the cage nuts in the two-post rack where you want to mount the device.
5.
Using a Phillips screwdriver, mount the device in a two-post rack using four rack-mounting
screws.
ICX 6450-C Installation
24
Brocade ICX 6450-C Compact Switch Hardware Installation Guide
53-1003081-01