Brocade ICX 6450-C Compact Switch Hardware Installation Guide - Manual (Page 34)

1 Magnet
2 Mylar sheet covering the bottom panel
FIGURE 16 Attaching the logo side of the magnet sheet to the bottom panel of the ICX 6450-C device
NOTE
Do not install the rubber feet or remove the rubber feet if they are already installed.
Mounting the device on a metal surface or metal wall
NOTE
When mounting the device on a vertical metal surface, Brocade recommends that you mount the
device with the port side down.
Complete the following steps to securely mount an ICX 6450-C device on a metal surface or metal
wall:
1. Ensure that the magnet sheet is attached to the bottom panel of the device. See Attaching the
magnet sheet to the device on page 31.
2. Place the magnet sheet (with the logo side now attached to the bottom panel of the device)
against the metal surface or metal wall. See the figures below.
Mounting the device on a metal surface or metal wall
32 Brocade ICX 6450-C Compact Switch Hardware Installation Guide
53-1003081-01