Brocade ICX 6450-C Compact Switch Hardware Installation Guide - Manual (Page 42)

Changing the temperature warning level
To change the temperature at which the device sends a warning message, enter a command similar to
the following at the Privileged EXEC level of the CLI.
device# temperature warning 83
Syntax: temperature warning decimalvalue
The decimal value variable is the temperature warning level, in Celsius. The possible values are
between 0 and 93°C. The temperature warning level must be at least 3 degrees Celsius less than the
temperature shut down level, which is automatically set by the device.
The following console and syslog message is displayed when the temperature reaches the warning
level:
!!! Temperature is over warning level on stack unit 1!!!
Temperature shutdown levels
When the temperature crosses the critical (shutdown) threshold levels, the device will reset after 5
minutes. The following console and syslog message is displayed:
!!! Temperature is over shutdown level, please shutdown your stack unit 1 to avoid
hw damage!!!
NOTE
Brocade recommends that you shut down your stack unit to avoid any hardware damage.
Changing the temperature warning level
40 Brocade ICX 6450-C Compact Switch Hardware Installation Guide
53-1003081-01