Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) User Manual
Page 84
64
Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002923-01
Configuring encryption storage targets
2
6. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
target information that displays when using the nsShow command.) You can also enter WWNs
manually, for example, to specify a target that is not on the list.
7. Select a target type from the Type list, then click Next.
The Select Hosts dialog box displays. (Refer to
.) You can configure hosts for selected
target device ports. All hosts that are in the same fabric as the encryption engine are listed.
NOTE
The selected target and initiator port must be in the same zone, or an error will result.
FIGURE 38
Select Hosts dialog box
The dialog box contains the following information:
•
Hosts in Fabric table: Lists the available hosts in the fabric.
•
Selected Hosts table: Lists the hosts that have been selected to access the target.
•
Port WWN: The world wide name of the host ports that are in the same fabric as the
encryption engine.
•
Node WWN: The world wide name of the host nodes that are in the same fabric as the
encryption engine.
•
Port Name: The user-assigned port name, if one exists; otherwise, the symbolic port name
from the device.
•
Port ID: The 24-bit Port ID of the host port.
•
VI Port WWN: The world wide name of the virtual initiator port.
•
VI Node WWN: The world wide name of the virtual initiator node.
•
Host Name: The name of the hosts that are in the same fabric as the encryption engine.
•
Port WWN text box: Type a world wide name for a host port.