Warnings, Site preparation, Warnings site preparation – Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) User Manual

Page 13

Advertising
background image

Warnings

1

Brocade Mobility RFS4000 Controller Installation Guide

3

53-1001933-02

Warnings

•

Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the system to its power source.

•

Remove jewelry and watches before installing this equipment.

•

Install the equipment in a rack or on a desktop with adequate dimensions and
weight allowances.

•

Verify the unit is grounded before connecting it to the power source.

•

Verify any device connected to this unit is properly wired and grounded.

•

Connect all power cords to a properly wired and grounded electrical circuit.

•

Verify the electrical circuits have appropriate overload protection.

•

Brocade strongly recommends the use of an Uninterruptible Power Supply
(UPS) that supports the Brocade Mobility RFS4000 Controller power rating. Not
using a UPS can result in data loss or equipment damage due to a power surge
or power failure.

•

Verify that the power connector and socket are accessible at all times during
the operation of the equipment.

•

Do not work with power circuits in dimly lit spaces.

•

Do not install this equipment or work with its power circuits during
thunderstorms or other weather conditions that could cause a power surge.

•

Verify there is adequate ventilation around the device, and ambient
temperatures meet equipment operation specifications.

•

This product is designed for in building installation only and is not intended to
be connected to exposed (outside plant) networks.

Site preparation

•

Consult your site survey and network analysis reports to determine specific
equipment placement, port capacity, power drops, and so on.

•

Assign installation responsibility to the appropriate personnel.

•

Identify where all installed components are located.

•

Verify appropriate rack mounting requirements, as required.

•

Provide a sufficient number of power drops for your equipment.

MobilityRFS4000ControllerInstallGuide.book Page 3 Friday, June 10, 2011 1:32 PM

Advertising