Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) User Manual
Page 33
Using the Brocade Mobility RFS4000 Controller reset button
4
Brocade Mobility RFS4000 Controller Installation Guide
23
53-1001933-02
Using the Brocade Mobility RFS4000 Controller reset
button
The Brocade Mobility RFS4000 Controller has a reset button on the rear of the
switch near the power connector.
To reset the switch to factory defaults:
1. Connect a computer to the Console Port as outlined in
RFS4000 Controller console port setup on page 4-20
2. Reset the switch using the Web UI or the Command Line Interface.
3. As soon as the switch resets, depress the reset button on the rear of the switch
and continue to hold it through the boot up process until the following message
is displayed in the console:
Startup config will be RESET to factory default
loading linux image 2 .......................
Welcome to RFS4000
Reset Button
MobilityRFS4000ControllerInstallGuide.book Page 23 Friday, June 10, 2011 1:32 PM