Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) - Manual (Page 28)

Connecting USB devices
4
18 Brocade Mobility RFS4000 Controller Installation Guide
53-1001933-02
Connecting USB devices
The Brocade Mobility RFS4000 Controller contains one USB port for connecting
USB flash storage devices to the controller. The controller can use the USB flash
storage device for file transfers and firmware updates. Follow the setup instructions
below to connect the devices to the controller and then access those devices
through the Web UI or Command Line Interface.
1. Connect the USB flash drive to the USB .
2. Wait a few seconds for the drive to be recognized by the controller.
3. Follow the instructions in the Brocade Mobility RFS4000, RFS6000 and
RFS7000 System Reference Guide or Brocade Mobility RFS4000, RFS6000
and RFS7000 CLI Reference Guide for more information on accessing USB
storage devices from the controller for file transfers or firmware updates. These
guides are available from the Brocade website at
http://www.brocade.com/support/
USB
port
MobilityRFS4000ControllerInstallGuide.book Page 18 Friday, June 10, 2011 1:32 PM