Burcam 506530SS S.W. STAINLESS STEEL SPRINKLER JET PUMP 3/4HP 115/230+HANDLE - Manual (Page 2)

SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR PRO-
TECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
A
B
C
D
Material required for drilled well application
(indoor use only)
Shallow well pump installation
RDesired length of polyethylene 1” pipe, 100 PSI, CSA or
UL approved, to link up from pumping level to pump.
R1 1” foot valve (750756 or 750752P).
R1 well seal, as per well casing diameter (750929 6” x 1”).
R1 1” well seal elbow (750860).
R2 1” male adaptors (750865 or 750871).
R8 1” stainless steel clamps (750885).
RTeflon tape.
2
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe
cutting, round file to smooth pipe ends, pipe wrench,
adjustable wrench to tighten fittings, propane torch and
welding material.
VOLTAGE SELECTION SWITCH
models since 2006
1. POWER off
2. Please SELECT the up knob position
for 115 V or down knob position for 230 V.
3. PUSH plug in to desired voltage.
VOLTAGE SELECTION SWITCH
2005 and older
1. POWER off
2. PULL selector plug out
3. ROTATE plug to align arrow to
desired voltage
4. PUSH plug in to desired voltage.