Burcam 506530SS S.W. STAINLESS STEEL SPRINKLER JET PUMP 3/4HP 115/230+HANDLE - Manual (Page 3)

3
APPLICATION
RThis pump is designed for shallow well
installation for water level up to 25 feet.
RCapacity:
Suction 506120S 506220S 503120S 503220S 506530SSN
5’ 715 800 710 754 897 US GPH
10’ 630 690 622 659 749 US GPH
15’ 575 625 548 581 638 US GPH
20’ 500 545 474 502 555 US GPH
25’ 450 480 437 463 472 US GPH
INSTALLATION STEPS
We recommend that you install your pump in a clean and dry location where
there is adequate room for servicing at a later date. Protection from freezing
temperatures and good ventilation should be considered as well, to provide the
pump an environment for long life. Locating the pump as close as possible to
the water source will reduce friction losses encountered in the suction pipe.
Friction losses in the suction pipe must be taken into consideration when the
horizontal offset is greater than 50 feet. The suction pipes should be increased
from 1” to 1 1/4”. This will reduce friction losses and allow the pump to give max-
imum performance.
A new well should be checked to determine that it is free from sand. Sand will
damage the seal and the impeller. Have your well driller clean the well before
your installation.
Never run the pump dry. Damage to the seal may occur. Fill pump body and
suction pipe with water before turning on the power.
THE RUN OF HORIZONTAL PIPE FROM THE TOP OF
YOUR WELL INTO THE HOUSE, WHERE YOUR PUMP
WILL BE LOCATED, MUST BE INSTALLED IN A TRENCH,
BELOW THE FROST LEVEL OF YOUR AREA.
STEP 1
FRICTION LOSS IN
PIPE NOT INCLUDED
FEATURES
RSpecially treated cast iron pump body or
stainless steel. Easy to prime
RTotally enclosed, fan cooled motor,
bearing to bearing. Built for a continuous use.
RFull time connected run capacitor, to eliminate
starting wear vs regular motor.
RThermal and overload protection.
RNoryl impeller, built-in injector
R1/2HP, 115VAC, 60Hz, 8A, (16A when start).
3/4HP, 115VAC, 60Hz, 9A, (18A when start).