Burcam 310100 CONDENSATE WATER PUMP - Manual (Page 2)

FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029
2
SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO
ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE
BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY
WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME
ELECTRICAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A
FUSE OR A CIRCUIT BREAKER. WE ALSO RECOMMEND THAT A GROUND
FAULT CIRCUIT BE USED. CONSULT A LICENSED ELECTRICIAN FOR ALL
WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER
BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR
PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. DO NOT ONLY UNSCREW
THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER PLUG FROM
THE RECEPTACLE.
FOR INDOOR USE ONLY. THIS PUMP IS NOT SUBMERSIBLE.
A
B
C
D
E
The overflow safety switch may be wired in series with the
appliance’s thermostat to shut off the unit in the event that the
pump fails.
In the case were heating or cooling requirements are a necessity,
the overflow safety switch may be wired into an alarm circuit.
Refer to schema at right for wiring.
NOTE:
In most cases, use the normally closed (NC) contacts when used with a furnace or air
conditioner and use the normally open (NO) contacts when used to trigger an alarm.
Safety switch connection
Illustration 1