Burcam 310100 CONDENSATE WATER PUMP - Manual (Page 3)

Tools
- Screw driver, knifes or cissors, wrench 9/16”
Teflon.tape
Carefully unpack unit. Check for damage and make sure all of the required parts are
included.
Choose a mounting location near the air conditionner or furnace. The pump must be
mounted level and the inlet must be below the lowest drain.
The unit has two brackets built into the deck that can be used to attach the unit to a wall
or to the side of the appliance with installed supplied fasteners.
.
Connecting the piping
On conditionner; system runs the flexible tubing or drain pipe to one of the inlet tank holes
on the pump.
On furnace; run flexible tubing or drain pipe to one of the inlet tank holes on the pump.
Whatever system used, this drain should have a continuous downward slope to allow
gravity flow.
Cut the end of the line at a angle so the end does not close off on bottom of the pump
holding tank (See illustration 2).
Material required tools for installation
INSTALLATION
APPLICATION
RThis pump is designed to remove automatically
the liquid from in air conditioners or warm
air furnaces.
R CAPACITY:
1’ 95 GPH US
4’ 85 GPH US
10’ 70 GPH US
15’ 45 GPH US
20’’ 0 GPH US
FEATURES
R Made from solid ABS
R Double insulated enclosure.
R Thermally and overload protected.
R Overflow safety switch
R 1.45 Amps, 115VAC, 60Hz. 67 Watts
R Specifications
Weight : 3.25 Lbs (1.5 kg)
Dimensions 11” X 5” X 4 3/4”
28 cm X 12,5 cm X 12 cm
Tank 2 Qts total
Capacity
FRICTION
LOSS IN
PIPE NOT
INCLUDED
STEP 1
STEP 2
STEP 3
STEP 4
3
FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029