Actron CP9190 - Manual (Page 162)

Chrysler Diagnostics
7 – 6 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
7
Record Data
✓
The Record Data function records vehicle PID data while the vehi-
cle is parked or being driven. This function is mainly used for diag-
nosing intermittent driveability problems that cannot be isolated by
any other method.
✓
The Scan Tool records data based on time (5 frames prior to the
start of the recording, and for a duration after). The time after
depends on the vehicle data rate.
✓
The Record Data function allows diagnosis of an intermittent prob-
lem by analyzing data leading up to the problem, during the prob-
lem, and possibly after the problem, depending on duration.
From the Datastream Menu:
1. Select Record Data.
•Use
UP or DOWN arrow
key until Record Data is
highlighted.
•Press ENTER .
✓
The Scan Tool can maintain only one recording at a time. Be sure
to thoroughly review the old recording before erasing it.
✓
If a recording currently exists in
memory, a message to Erase Old
Recording is displayed. The Scan
Tool stores only one recording at a
time, so be sure to review it before
erasing it.
•Next, turn the ignition key on. Engine can be off or running.
2. Refer to “Record Data” on page 4-9 of
Global OBD II Diagnostics.

View Data
Record Data
Sensor Test
Review Data
Print Data
Tool Setup
Datastream Menu
Previous recording
in memory. Do you
want to erase it and
make a new one?
<Yes> <No>
Record Data