Actron CP9190 - Manual (Page 167)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 7 – 11
Chrysler Diagnostics
7
Device Controls Menu
All items marked with “-” are covered in section 3 or 4.
These items are not covered in this section.
❒
Device Controls Menu
❒
Switch Test
❒
Actuator Test
❒
Idle Speed Test
– Review Data
– Print Data
– Tool Setup
Switch Test
✓
The Switch Test is used to test the operation of switches on var-
ious Chrysler vehicle systems. These systems may include cruise
control, A/C, braking, and the shift lever position.
✓
Because of differences in vehicle designs, the Switch Test may
not test the same switches in every car.
NOTE: Switch Test is only available on 1989-1995 Chrysler vehicles.
From the Device Controls Menu:
1. Select Switch Test.
•Use
UP or DOWN arrow
key until Switch Test is
highlighted.
•Press
ENTER.
2. Select switch to test.
•Use the
UP or DOWN
arrow key.
•Press
ENTER.
✓
Switches for the engine and
transmission are combined into
one list when applicable.
IMPORTANT


Switch Test
Actuator Test
Idle Speed Test
Review Data
Print Data
Tool Setup
Device Controls Menu
A/C CLUTCH REL
A/C SWITCH SEN
A/C REQUEST
AIR SW SOL
ASD RELAY
BRAKE SWITCH
CHECK ENG LT
Select Sw to Test