Elitegroup VX900-I2 (V1.0) - Manual (Page 37)

Chapter 3
VX900-I2 USER MANUAL
33
Resume By USB (S3) (Disabled)
This item allows you to enable/disable the USB device wakeup function from S3
mode.
Resume By RING (Disabled)
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming call
on the modem) awakens the system from a soft off state.
Resume By PS2 MS (S3) (Disabled)
This item enables or disables you to allow mouse activity to awaken the system
from power saving mode.
Resume By PS2 KB (S3) (Disabled)
This item enables or disables you to allow keyboard activity to awaken the system
from power saving mode.
Power Management Setup
This page sets up some parameters for system power management operation.
Select the ACPI
state used for
System Suspend.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type (Auto)
Use this item to define how your system suspends. When set this item to Auto, the
system will automatically select the suspend mode(S1 or S3).
Help Item
PWRON After PWR-Fail (Power Off)
This item defines how the system will act after AC power loss during system opera-
tion. When you set to off, it will keep the system in Off state until the power button
is pressed.
ACPI Suspend Type Auto
PWRON After PWR-Fail Power Off
Resume By RING Disabled
Resume By PCI/PCI-E/Lan PME Enabled
Resume By USB (S3) Disabled
Resume By PS2 KB (S3) Disabled
Resume By PS2 MS (S3) Disabled
Resume On RTC Alarm Disabled
EUP Support Enabled
Resume By PCI/PCI-E/Lan PME (Enabled)
These items specify whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
F1:General Help
: Move F10: Save and Exit +/-/PU/PD: Value Enter : Select
F9: Load Default Settings ESC: Exit
Resume On RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system’s RTC
(realtime clock). Use the items below this one to set the date and time of the wake-
up alarm. You must use an ATX power supply in order to use this feature.