Elitegroup H61H2-M19 (V1.0) - Manual (Page 47)

Chapter 3
H61H2-M19 USER MANUAL
43
Super IO Chip (IT8786, IT8768)
This item shows the information of the super IO chip.
Super IO Configuration
Use this item to show the information of Super IO configuration.
Super IO Configuration
Super IO Chip IT8786, IT8768
Serial Port 1 Configutation
Serial Port 2 Configuration
Serial Port 3 Configuration
Serial Port 4 Configuration
Serial Port 5 Configuration
Serial Port 6 Configuration
Serial Port 7 Configuration
Serial Port 8 Configuration
Serial Port 9 Configuration
Serial Port 10 Configuration
Parallel Port Configuration
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced Chipset M.I.B III Boot Security Exit
Version 2.15.1229. Copyright (C) 2012 American Megatrends, Inc.
Set Parameters of Serial Port
1 (COMA)
    
F1:General Help
+/- : Change Opt.
Enter : Select


:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
    
Serial Port 1 Configuration
Scroll to this item and press <Enter> to view the following screen:
Serial Port (Enabled)
This item allows you to enable or disable serial port.
Device Settings (IO=3F8h; IRQ=4)
This item shows the information of the device settings.
Change Settings (Auto)
Use this item to change device settings.
Serial Port 1 Configuration
Serial Port [Enabled]
Device Settings IO=3F8h; IRQ=4;
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1229. Copyright (C) 2012 American Megatrends, Inc.
Enable or Disable Serial Port
(COM)
Change Settings [Auto]
RS485 Mode [Disabled]
9-bit Multi-Drops Mode [Disabled]
Main Advanced Chipset M.I.B III Boot Security Exit
    
    
    
    
    
    
    
    
    
    
RS485 Mode (Disabled)
Use this item to enable or disable the RS485 mode.
Press <Esc> to return to the Super IO Configuration page.
9-bit Multi-Drops Mode (Disabled)
Use this item to enable or disable the 9-bit Multi-Drops mode.
ESC:Exit
F1:General Help
+/- : Change Opt.
Enter : Select


:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit