Elitegroup H61H2-M19 (V1.0) - Manual (Page 72)

Chapter 3
H61H2-M19 USER MANUAL
68
This page enables you to set the keyboard NumLock state.
Boot Menu
Operation System Select (Windows 7 or other OS)
This item is used to select the operation system.
Launch PXE OpROM (Disabled)
The item enables or disables launch PXE Option ROM.
Launch Storage OpROM (Enabled)
Use this item to enable or disable the Storage OpROM.
Fast Boot ( Enabled )
Use this item to enable or disable boot with initialization of a minimal set of devices
required to launch active boot option. Has no effect for BBS boot options.
VGA Support (
EFI Driver ) *
If auto, only install legacy OpROM with legacy OS and Post logo will not be shown
during post. EFI driver will still be installed with EFI OS.
USB Support (
Full Initial ) *
If you select Disabled, all USB devices will not be available until after OS boot. If you
select Partial Initial, specific USB port/device will not be available before OS boot.
If you select Full Initial, all USB devices will be available in OS and POST.
PS2 Devices Support (
Enabled ) *
Use this item to enable or disable PS2 devices support. If enabled, PS2 devices will
be initialized during boot. If disabled, PS2 devices will be skipped during boot to
optimize the boot time.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1229. Copyright (C) 2012 American Megatrends, Inc.
Enables or disables boot with
initialization of a minimal set of
devices required to launch active
boot option. Has no effect for BBS
boot options.
Main Advanced Chipset M.I.B III Boot Security Exit

F1:General Help
+/- : Change Opt.
Enter : Select

:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Boot Configuration
Operating system select [Windows 7 or othre OS]
Launch PXE OpROM [Disabled]
Launch Storage OpROM [Enabled]
Fast Boot [Enabled]
VGA Support [EFI Driver]
USB Support [Full Initial]
PS2 Devices Support [Enabled]
Network Stack Driver Support [Disabled]
Bootup NumLock State [On]
Boot mode select [LEGACY]
Set Boot Priority
Boot Option #1
[Hard Disk: WDC WD5000AAJS-22A8B]
Boot Option #2 [CD/DVD]
Boot Option #3 [USB/Floppy]
Boot Option #4 [USB CD/DVD]
Boot Option #5 [USB Hard Disk]
Boot Option #6 [USB Flash: Ut165 1.00]
Boot Option #7 [Network]
Hard Disk Drive BBS Priorities
USB Key Drive BBS Priorities

