FallTech Sling Anchors - Manual (Page 23)

45
All Cable Sling Anchors and Extenders
(Located next to formed eye)
10.4: Standards and references
Below is a listing of standards that are applicable to the construction
and use of this product. FallTech strongly encourages that all employers
acquire and utilize these documents for the creation of your own fall
protection policies and your individual fall protection plans. Users of this
product should also be familiar with this information as well.
OSHA Standards bear the force of law on a federal level. Some
states have their own regulations which are locally enforced – check with
your State Department of Labor for specific requirements which may be
enforced in your area. OSHA Standards can be accessed for free at
www.osha.gov.
29 CFR 1926 (Subpart M)
1926.500: Scope, Application and Definitions
1926.501: Duty to Have Fall Protection
1926.502: Fall Protection Systems Criteria & Practices
1926.503: Training Requirements
FALLTECH 800-719-4619
DO NOT REMOVE LABEL
PART#: 84202DC4 4’ ANCHOR CABLE
CAPACITY: 425 LBS.
DATE OF MFG: 01/2012
LOT #: 013112
MATERIAL: ¼” COATED GALV CABLE
MEETS OR EXCEEDS OSHA AND
ANSI Z359.1-2007 REQUIREMENTS
!WARNING!
READ AND UNDERSTAND
MANUFACTURER’S INSTRUCTIONS,
LABELS AND WARNINGS AT ALL
TIMES. AVOID CONTACT WITH SHARP
EDGES AND THERMAL, ELECTRICAL
OR CHEMICAL HAZARDS. USE ONLY
APPROVED CONNECTING DEVICES
AND MAKE ONLY PROPER
ATTACHMENTS. REFER TO OWNER’S
MANUAL FOR FURTHER INFORMATION.
INSPECT BEFORE EVERY USE.
46
ANSI standards are voluntary consensus standards, and are
generally regarded among the best practices where fall protection is
concerned. Some states have incorporated one or more of the ANSI
standards by reference, meaning that they may be enforced by some
state or local agencies. Check with your State Department of Labor for
further details. ANSI standards are available for purchase through the e-
standards store at www.ansi.org.
ANSI Z359.1-2007: Safety Requirements for Personal Fall Arrest
Systems, Subsystems and Components
ANSI Z359.2-2007: Minimum Requirements for a Comprehensive
Managed Fall Protection Program
ANSI Z359.12-2009: Connecting Components for Personal Fall Arrest
Systems
ANSI A10.32-2004: Fall Protection Systems for Construction and
Demolition Operations