FallTech 83663 - Manual (Page 19)

19
Section 9: Maintenance and Storage
The service life of your FallTech D-ring Extender will depend on two factors: The environmental
conditions of your working environment along with proper care (specifically, maintenance and
storage).
Keeping the D-ring Extender clean and free of contaminants will greatly increase the service
life and will ensure that the D-ring Extender will be in proper working order in the event that you
need it to arrest a fall. The following steps should be taken periodically:
1. Using a damp rag and a mild soap and water solution, wipe down the surface D-ring
Extender to remove soil and surface contaminants. Ensure that the labels are legible at
all times.
2. Use a damp rag to clean the surfaces of any connecting hardware.
3. If there is an excessive build up of paint, oil, dirt tar or other contaminants that cannot be
removed, remove the D-ring Extender from service and have it replaced.
4. If any moving parts require lubrication, use a light application of 100% silicon spray. Do
not use petroleum-based lubricants.
5. Store in a cool, dry location away from direct sunlight and where it will not be exposed to
chemical vapors.
6. This D-ring Extender should be hung on a rack or a peg or stored flat on a shelf.
7. Do not throw the D-ring Extender into a pile or a locker or storage box, as this may cause
damage.
Provided your D-ring Extender passes inspection, has been properly maintained, has not
been involved in arresting a fall and is in serviceable condition, it will be suitable for use. If your
D-ring Extender is in need of repair or you are concerned about its condition, return it to the place
of purchase to arrange an inspection and/or repair through an authorized service center. For
further details, contact FallTech.
Section 10: Specifications
This section contains important information regarding the performance and construction of this
product. Please read and be familiar with this and all information contained in this instruction
manual.
10.1: Mandatory Disclosures
This instruction manual addresses foreseeable hazards, uses and applications. If you have
questions about your application that are not addressed in this document, contact FallTech for
additional guidance.
It is the responsibility of the employer/issuer of this equipment to ensure that it is used in a
manner consistent with these instructions. Failure to do so could result in series injury or death.
For further reading and additional information, see Section 10.4 for a listing of relevant
standards with which you should be familiar.
10.2: Performance Specifications
All FallTech D-ring Extenders meet the requirements of Title 29 CFR, Subpart M (OSHA
1926.502). Model #’s beginning with “7” also comply with ANSI/ASSE A10.32-2004. Model #’s
beginning with “8” also comply with ANSI/ASSE Z359.1-2007.